e-ManualTopSite mapHelp

Category Top

Overview of This Function

Registering Custom Paper Types

Changing the Name

Changing the Basis Weight

Changing the Size

Changing the Finishing Type

Changing the Type

Changing the Color

Setting the Second Side of Two-Sided Page

Adjusting the Creep (Displacement) Correction

Changing the Fiber Direction

Adjusting the Level of Curl Correction

Adjusting Fan Level for Paper Separation

Adjusting Paper Conveyance for 2-Sided Printing

Adjusting the Image Position

Correct Image Misalignment

Adjusting the Skew Correction Level of the Fed Paper

Correct Distortion (Parallelogram)

Correct Distortion (Trapezoid)

Adjusting the Zoom Ratio of the Image

Adjusting Left Edge Alignment of the Image

Adjusting Lead Edge Alignment of the Image

Automatically Correcting the Back Side Lead Edge Alignment of the Image

Adjusting Front/Back Side Edge Alignment of the Image by Scanning the Guide Sheet

Adjusting the Lead Edge/Tail End Margins

Adjusting the Total Amount of Toner

Adjusting the Secondary Transfer Voltage

Adjusting the Secondary Transfer Antistatic Bias

Adjusting the Image Clear Level of the ITB (Intermediate Transfer Belt)

Adjusting Secondary Transfer Belt Speed

Adjusting the Gloss and Fine Black

Adjusting the Saddle Stitch Position

Adjusting the Saddle Stitch Fold Placement

Adjusting the Saddle Fold Placement

Adjusting the Position of Punch Holes

Changing the Tail End White Patch Correction

Disabling Tail End Toner Correction

Adjusting the Primary Transfer Voltage

Adjusting Lead Edge Secondary Transfer Voltage

Deleting Custom Paper Types

Top » Paper Type Management » Adjusting the Creep (Displacement) Correction
Adjusting the Creep (Displacement) Correction
0S9Y-055
If you want to change the creep (displacement) correction for each page in a booklet, adjust the creep correction width for the registered custom paper type.
NOTE
For more information on creep (displacement), see "Booklet Mode" in "Copy" and "Booklet Mode" in "Access Stored Files."
The value set in this mode is used as the default value for the automatic creep (displacement) correction in the Saddle Stitching mode.
1.
Press (Settings/Registration).
2.
Press [Preferences] → [Paper Settings] → [Paper Type Management Settings].
3.
Select the paper type that you want to edit from the list → press [Details/ Edit].
4.
Press [Change] for <Adjust Creep Correction>.
5.
Press [] or [] to adjust the correction width → [OK].
6.
Press [OK].
Back to Top