e-ManualTopSite mapHelp

Category Top

Overview of This Function

Registering Custom Paper Types

Changing the Name

Changing the Basis Weight

Changing the Size

Changing the Finishing Type

Changing the Type

Changing the Color

Setting the Second Side of Two-Sided Page

Adjusting the Creep (Displacement) Correction

Changing the Fiber Direction

Adjusting the Level of Curl Correction

Adjusting Fan Level for Paper Separation

Adjusting Paper Conveyance for 2-Sided Printing

Adjusting the Image Position

Correct Image Misalignment

Adjusting the Skew Correction Level of the Fed Paper

Correct Distortion (Parallelogram)

Correct Distortion (Trapezoid)

Adjusting the Zoom Ratio of the Image

Adjusting Left Edge Alignment of the Image

Adjusting Lead Edge Alignment of the Image

Automatically Correcting the Back Side Lead Edge Alignment of the Image

Adjusting Front/Back Side Edge Alignment of the Image by Scanning the Guide Sheet

Adjusting the Lead Edge/Tail End Margins

Adjusting the Total Amount of Toner

Adjusting the Secondary Transfer Voltage

Adjusting the Secondary Transfer Antistatic Bias

Adjusting the Image Clear Level of the ITB (Intermediate Transfer Belt)

Adjusting Secondary Transfer Belt Speed

Adjusting the Gloss and Fine Black

Adjusting the Saddle Stitch Position

Adjusting the Saddle Stitch Fold Placement

Adjusting the Saddle Fold Placement

Adjusting the Position of Punch Holes

Changing the Tail End White Patch Correction

Disabling Tail End Toner Correction

Adjusting the Primary Transfer Voltage

Adjusting Lead Edge Secondary Transfer Voltage

Deleting Custom Paper Types

Top » Paper Type Management » Adjusting Lead Edge Secondary Transfer Voltage
Adjusting Lead Edge Secondary Transfer Voltage
0S9Y-1LC
If the area approximately 40 mm from the head of paper is lighter or darker than the other areas, adjust the Lead Edge Secondary Transfer Voltage (the voltage for transferring toner to the paper) for the user-registered paper.
IMPORTANT
This function is displayed only if the settings are made available by your local authorized Canon dealer. Even if this function is displayed, do not allow anyone to change the settings except for the system manager. For more information on changing the settings, contact your local authorized Canon dealer.
1.
Press (Settings/Registration).
2.
Press [Preferences] → [Paper Settings] → [Paper Type Management Settings].
3.
Select the paper type that you want to edit from the list → press [Details/Edit].
4.
Press [Change] for <Adj Ld Edge Sec. Trans. Volt.>
5.
Press [-] or [+] for front side and back side to adjust the voltage → [OK].
Details of each item are shown below:
[Correction Level]:
If high-density areas of images are too light in environments with a high temperature or humidity, adjust to the [+] side from the current value. Note that if the value is too large, a density change is likely to occur in low density parts of the image.
If the image is too dark or too light in environments with a low temperature or humidity, adjust to the [-] side from the current value. Note that if the value is too small, a density change is likely to occur in high density parts of the image. If the density is different only in the low density parts of an image, adjust to the [+] and [-] sides as necessary.
[Correction Amount]:
If an adequate image cannot be output by adjusting [Correction Level], adjust the position to start correction. Enter a value, regarding the position 20 mm from the head as 0.
6.
Press [OK].
Back to Top