e-ManualTopSite mapHelp

Category Top

Overview of This Function

Registering Custom Paper Types

Changing the Name

Changing the Basis Weight

Changing the Size

Changing the Finishing Type

Changing the Type

Changing the Color

Setting the Second Side of Two-Sided Page

Adjusting the Creep (Displacement) Correction

Changing the Fiber Direction

Adjusting the Level of Curl Correction

Adjusting Fan Level for Paper Separation

Adjusting Paper Conveyance for 2-Sided Printing

Adjusting the Image Position

Correct Image Misalignment

Adjusting the Skew Correction Level of the Fed Paper

Correct Distortion (Parallelogram)

Correct Distortion (Trapezoid)

Adjusting the Zoom Ratio of the Image

Adjusting Left Edge Alignment of the Image

Adjusting Lead Edge Alignment of the Image

Automatically Correcting the Back Side Lead Edge Alignment of the Image

Adjusting Front/Back Side Edge Alignment of the Image by Scanning the Guide Sheet

Adjusting the Lead Edge/Tail End Margins

Adjusting the Total Amount of Toner

Adjusting the Secondary Transfer Voltage

Adjusting the Secondary Transfer Antistatic Bias

Adjusting the Image Clear Level of the ITB (Intermediate Transfer Belt)

Adjusting Secondary Transfer Belt Speed

Adjusting the Gloss and Fine Black

Adjusting the Saddle Stitch Position

Adjusting the Saddle Stitch Fold Placement

Adjusting the Saddle Fold Placement

Adjusting the Position of Punch Holes

Changing the Tail End White Patch Correction

Disabling Tail End Toner Correction

Adjusting the Primary Transfer Voltage

Adjusting Lead Edge Secondary Transfer Voltage

Deleting Custom Paper Types

Top » Paper Type Management » Adjusting the Saddle Stitch Fold Placement
Adjusting the Saddle Stitch Fold Placement
0S9Y-062
If you notice that the folds of the paper are not in the center of the booklet, but the stitches are in the center, you can make adjustments to the saddle stitch fold placement on the custom paper type.
This mode can be set when the Saddle Finisher-AN2 is attached. (See "Finisher-AN1/Saddle Finisher-AN2/Puncher Unit-BS1/Puncher Unit-BT1.")
IMPORTANT
This function is displayed only if the settings are made available by your local authorized Canon dealer. Even if this function is displayed, do not allow anyone to change the settings except for the system manager. For more information on changing the settings, contact your local authorized Canon dealer.
NOTE
If both the saddle stitch position and fold placement are not aligned with the center of the paper, match the fold placement to the saddle stitch position according to <Adj. Saddle Stitch Fold Pos.>, and then adjust the saddle stitch position and fold placement according to <Change Fold/Stitch Position>. <Adj. Saddle Stitch Fold Pos.> adjusts only the fold placement, while <Change Fold/Stitch Position> adjusts both the saddle stitch position and the fold placement. For details on adjusting the saddle stitch position of the paper, see "Adjusting the Saddle Stitch Position."
1.
Press (Settings/Registration).
2.
Press [Preferences] → [Paper Settings] → [Paper Type Management Settings].
3.
Select the paper type that you want to edit from the list → press [Details/ Edit].
4.
Press [Change] for <Adj. Saddle Stitch Fold Pos.>.
5.
Press [] or [] to adjust the saddle stitch fold placement → [OK].
If you want the saddle fold to shift to the right, increase the setting value.
If you want the saddle fold to shift to the left, decrease the setting value.
6.
Press [OK].
Back to Top