e-ManualTopSite mapHelp

Chapter Top

Checking Your Network Environment

Example of a Windows Network

Example of a Macintosh Network

Example of a UNIX Network

Example of a Network Using a Variety of Computers

Network Settings for the Printer (Common to Each Protocol)

Changing the Network Transmission Speed or Transfer Mode

Performing the Configuration Using the Printer's Control Panel (When You First Set it Up)

Changing the Settings Using Web Browser (Remote UI)

Setting the Spooling Function

Performing the Configuration Using the Printer's Control Panel (the Settings to Be Performed First)

Changing the Settings Using Web Browser (Remote UI)

Specifying the Setting for Startup Waiting Time

Performing the Configuration Using the Printer's Control Panel (When You First Set it Up)

Changing the Settings Using Web Browser (Remote UI)

Restricting the Users Who Can Monitor/Change the Settings Using the SNMP Protocol

Setting IEEE802.1X Authentication

Setting TLS Authentication Information

Setting TTLS/PEAP Authentication Information

Network Setting Items

Initializing the Network Settings

Initializing the Network Settings Using the Printer's Control Panel

Checking the MAC Address

Network Settings for the Printer (TCP/IP)

Setting the IP Address (IP v. 4)

Setting the IP Address Using the Printer's Control Panel

Setting the Printer to a Static IP Address
Determining Which IP Address to Assign to the Printer

Setting the IP Address Using the ARP/PING Commands

Setting the IP Address Using NetSpot Device Installer

Configuring the Protocol Settings

Attention (Protocol Settings)

Setting IP v. 6

Configuring a Computer that Performs Printing

Features of LPD

Features of RAW

Features of IPP/IPPS

Features of WSD

Connecting the Printer (LPD/RAW)

Values for Setting a Port

Connecting the Printer (IPP/IPPS)

Obtaining the Public Key for This Printer When Using SSL Encrypted Communication

Connecting the Printer (WSD)

Network Settings for the Printer (NetWare) 

Attention (NetWare Network Settings)

Configuring NetWare

Configuring the Protocol Settings

Network Settings for the Printer (SMB)

Attention (SMB Network Settings)

Configuring the Protocol Settings

Configuring a Computer that Performs Printing

Network Settings for the Printer (AppleTalk)

Macintosh Network Settings

Configuring the Protocol Settings

FTP Client (Macintosh)

Configuring a Computer that Performs Printing

Top » Configuring the Network Settings (Sharing the Printer) » Network Settings for the Printer (Common to Each Protocol) » Setting the Spooling Function
Setting the Spooling Function
07E3-07R
Specify the setting for the spooler function using either of the following methods.
"Performing the Configuration Using the Printer's Control Panel (the Settings to Be Performed First)"
Specify the setting for the spooler function using the control panel while checking the display on the printer.
"Changing the Settings Using Web Browser (Remote UI)"
Specify the setting for the spooler function by accessing the printer from a Web browser via the network.
IMPORTANT
When specifying the setting for startup waiting time first
Use the printer's control panel. After configuring the TCP/IP protocol settings, you can change the settings using the Web browser (Remote UI) or FTP Client.
Because the options which can be specified vary depending on the software, see "Network Setting Items" and use each software appropriate to the environment you are using or options that you want to specify.
The Spooling Function
It can only be used when the SD card is installed.
NOTE
Changing the settings using FTP Client
You can also specify the setting for startup waiting time using FTP Client.
"FTP Client"
Back to Top