SMB/CIFS Network Setup Procedures

To use an SMB/CIFS network, it is necessary to perform the following procedures.

Specify the protocol settings. To specify the settings, use one of the following:

The machine's control panel

The Remote UI (via a Web browser)

Specify the settings of each computer you use for printing. (Optional equipment may be required for printing from computers, depending on the model of your machine. For information on the optional products required, see "Optional Equipment and System Requirements.")

3 Setting Up a Computer as a File Server

Specify the settings of the computer receiving data sent from the machine.

IMPORTANT
It is recommended that you consult the administrator for the network you are using when performing the settings in steps 1 and 3. The only base protocols supported by the machine for SMB/CIFS networks are TCP/IPv4 and TCP/IPv6. NetBEUI is not supported (SMB is used as a print application). If you are using the imagePRESS Server, see the manual provided with the imagePRESS Server. If you are using the imagePRESS Server, some functions are not available with this machine. For details, see the manual provided with the imagePRESS Server.

IMPORTANT

It is recommended that you consult the administrator for the network you are using when performing the settings in steps 1 and 3.

The only base protocols supported by the machine for SMB/CIFS networks are TCP/IPv4 and TCP/IPv6. NetBEUI is not supported (SMB is used as a print application).

If you are using the imagePRESS Server, see the manual provided with the imagePRESS Server.

If you are using the imagePRESS Server, some functions are not available with this machine. For details, see the manual provided with the imagePRESS Server.