IMPORTANT
|
Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple cartridge, discard the punch waste, discard the trim waste, discard the staple waste, or clear paper or staple jams, prints may still be output if other optional units are operating normally, and are not involved in the paper or staple jam removal procedure.
|
NOTE
|
The Finisher-AM1 and Saddle Finisher-AM2 are optional products.
|
NOTE
|
If the staple case is difficult to be pull out as the stapler unit is located at the back, close the front cover of the finisher and wait for a few seconds until the stapler unit stops moving.
|
![]() |
When closing the cover, be careful not to get your fingers caught, as this may result in personal injury.
|