Scan and Send > Specifying Destinations > Destinations Not Stored in the Address Book > File Server > Using the Browse Key (Windows (SMB))
*
Using the Browse Key (Windows (SMB))

Return to Overview

  1. Press [New Destination].
  1. Press [File].
  1. Press the Protocol drop-down list → select [Windows (SMB)].
  1. Press [Browse].
  • After turning the main power ON, you must wait for the time set in [Startup Settings] to elapse before pressing [Browse]. Network transmission is not possible until this startup time has elapsed. (See "Startup Time Settings.")

  1. Select the desired workgroup.

You can also select the workgroup from a list of Active Directory server domain names that are registered in the machine by pressing [Directory] from the drop-down list.

  • If you want to register a Directory server domain name:
  • If you are not performing the above operation, proceed to the next step.

  • If you want to register a Directory server domain name:
  • Press [Register].
  • Enter a domain name → press [OK].
  • You can register up to five Directory servers.
  • To edit the domain name, select the domain name that you want to edit → press [Edit].
  • To delete the domain name, select the domain name that you want to delete → press [Delete] → press [Yes] on the pop-up screen that appears when you press [Delete].

  1. Select the desired file server → press [Down].

To move up one level, press [Up].
  1. If the Enter Network Password screen is displayed, enter your user name and network password.
  • Specify each setting → press [OK].

[User Name]:

Press [User Name] → enter your user name → press [OK].

[Password]:

Press [Password] → enter your network password → press [OK].

After pressing [OK], the password that you entered appears as asterisks (********) on the Enter Network Password screen.

  • Searching for a destination via an LDAP server is not possible if the time setting of the server and the time setting of the machine are more than five minutes apart. If you cannot send even when the user name and password are correct, check the time settings on the server and the machine.
  1. Press [Down] → select the folder on the specified server to which you want to send your documents → press [OK].

To go down one level, press [Down].

To move up one level, press [Up].
  1. To add destination, press [Next Destination] and repeat the procedure from steps 3 to 8.
  1. Confirm your settings → press [OK].

  • Back To Top