Security > Setting Remote UI
*
Setting Remote UI

To "Settings/Registration Table"

You can set whether to enable the Remote UI (User Interface) to operate the machine and change settings.

Remark
  • For more information on the Remote UI, see "Remote UI."

  1. Press (Settings/Registration) → [Management Settings] → [License/Other] → [Remote UI].
  1. Select [On] or [Off].

Details of each item are shown below.

[On]: Settings can be specified and the machine can be operated through the Remote UI.
[Off]: Settings cannot be specified and the machine cannot be operated through the Remote UI.
  • If you select [On]:
  • If you select [Off]:

  • If you select [On]:
  • Select [On] or [Off] for <Use SSL> → press [OK].

<Use SSL>

[On]: SSL is used to communicate.
[Off]: SSL is not used to communicate.

<Use Reference Print>

[On]: Prints with URL specified.
[Off]: Cannot print with URL specified.

  • If you select [Off]:
  • Press [OK].
  • Before setting <Use SSL> to 'On', it is necessary to set a default key in [Preferences] ( Settings/Registration). (See "Changing the Key Pair Used With SSL Encrypted Communications.")
  • Any changes made to <Use SSL> are also applied to <Use SSL> in [MEAP Settings] in [Management Settings] (Settings/Registration). (See "MEAP Settings.")
  • The Remote UI is enabled only after you restart the machine (the main power switch is turned
    OFF, and then back ON). For instructions on restarting (turning the main power switch OFF and then ON) the machine, see "Before You Start Using This Machine."

  • Back To Top