e-Manual
|
Top ContentsHelpGlossary |
||
|---|---|---|---|
|
Category
|
|
Category Top
Setting the System Manager InformationAttention (Specifying the System Manager Information)Registering the Name of the Machine and Location Specifying the Setting for Department ID ManagementRegistering DepartmentsEditing DepartmentsActivating the Department ID ManagementSpecifying Whether or Not to Receive a Print Job from an Unknown IDChecking or Clearing the Count InformationSpecifying Keys and Certificates/CA CertificatesGenerating Keys and CertificatesInstalling Keys and Certificates/CA CertificatesVerifying Keys and Certificates/CA CertificatesRegistering Keys and Certificates/CA CertificatesDeleting Keys and Certificates/CA CertificatesSpecifying SSLSetting IEEE802.1X AuthenticationSetting TLS Authentication InformationSetting TTLS/PEAP Authentication InformationSwitching On/Off for IEEE802.1X AuthenticationChecking Error Information for IEEE802.1X AuthenticationAttention (IEEE802.1X Authentication)Entering PIN for Printing (Secure Printing) Setting Secure PrintingPrinting by Secure PrintingConfiguring the Remote UI
Restricting Network ConnectionsRestricting Sending/Receiving to/from Specific IP AddressesRestricting Sending/Receiving to/from Specific MAC AddressesMonitoring/Controlling Devices by SNMP (SNMP Setting)Setting SNMPv1Setting SNMPv3Obtaining Printer Management Information from HostSetting the Permission for HTTP CommunicationsSetting Protocol Port NumbersSetting the Dedicated PortRestricting to Specify Destinations and Use the Sending Functions Setting a PIN for the Address BookRestricting Destinations that Can Be SpecifiedRestricting to Send Faxes from Your Computer Restricting Sending from Job HistoryConfirming the Entered Fax Number Restricting Sequential BroadcastsSpecifying Display Settings for the Job HistoryRestricting USB Port or USB Memory UsageRestricting External Device Connections via USBRestricting Storing of Data in Memory MediaRestricting Printing of Data in Memory Media|
NOTE
|
|
When <Wireless LAN> is selected in <Select Wired/Wireless LAN>:
The setting in this section is disabled.
A number of MAC addresses that can be specified
Up to 32 MAC addresses can be specified.
|
|
(1)
|
Select the [Use Filter] check box.
|
|
(2)
|
Select the [Reject] or [Allow] check box.
|
|
[Reject]
|
Allow accessing only from computers of which addresses specified in [Exception Addresses].
|
|
[Allow]
|
Reject accessing from computers of which addresses specified in [Exception Addresses].
|
|
IMPORTANT
|
||
|
When the [Use Filter] check box is selected:
You cannot access from the following MAC addresses. Make sure to enter the correct MAC address.
MAC addresses not specified for [Exception Addresses] in [Reject]
MAC addresses specified for [Exception Addresses] in [Allow]
|
|
(1)
|
Enter the MAC address.
|
||
|
(2)
|
Click [Add].
|
|
NOTE
|
||||
|
To delete registered MAC addresses
 |
|
IMPORTANT
|
|
When the setup is complete
Restart the machine to take effect the settings.
|
] (Menu).
] or [
] and press [OK].
] (Log In/Out).
] or [] and press [OK].
] or [] and press [OK].
] or [] and press [OK].
] or [] and press [OK].
|
<Off>
|
MAC address filter is not available.
|
|
<On>
|
MAC address filter is available.
|
] (Menu) to close the menu screen.| © CANON Inc. 2012 All Rights Reserved. | Disclaimer CopyrightTrademarksOffice LocationsUSRM2-1719 (00) |
|---|
