Registering the Paper Size and Type for a Paper Source

You can register the paper size and type for each paper source. This setting enables you to achieve the appropriate print results.

IMPORTANT
Be sure to correctly set the paper type. If the type of paper is not set correctly, it could adversely affect the quality of the image. Moreover, the fixing unit may become dirty and require a service repair, or the paper could jam.

Load paper in the paper source.

NOTE
For more information on the available paper for each paper sources, see "Available Paper Stock." For more information on how to load paper, see "Loading Paper."

Press

(Settings/Registration).

Press [Preferences] → [Paper Settings] → [Paper Settings].

Select the button for the paper source in which paper is loaded → press [Set].

The numbers on the screen represent the following paper sources:

The POD Deck Lite-C1 is attached.

: Right Paper Drawer

: Left Paper Drawer

: POD Deck Lite-C1

The POD Deck-D1/Secondary POD Deck-D1 is attached.

: Right Paper Drawer

: Left Paper Drawer

: Upper Paper Deck of the POD Deck-D1

: Middle Paper Deck of the POD Deck-D1

: Lower Paper deck of the POD Deck-D1

: Upper Paper Deck of the Secondary POD Deck-D1

: Middle Paper Deck of the Secondary POD Deck-D1

: Lower Paper Deck of the Secondary POD Deck-D1

Select the same paper type as the one you loaded → press [Next].

You can select the paper type from the simple or detailed setting screen. For paper types that are not displayed on the simple setting screen, press [Detailed Settings] → select the paper type from the detailed setting screen.


Simple Settings Screen	Detailed Settings Screen

NOTE
You can register paper types if paper types for the loaded paper are not displayed on the detailed setting list. For instructions on registering paper types, see "Overview of This Function." While you are registering the custom paper type for a paper source, the paper type settings are protected and you cannot change the detailed information for custom paper type or delete the custom paper type in [Paper Type Management Settings] in [Preferences] (Settings/Registration).

NOTE

You can register paper types if paper types for the loaded paper are not displayed on the detailed setting list. For instructions on registering paper types, see "Overview of This Function."

While you are registering the custom paper type for a paper source, the paper type settings are protected and you cannot change the detailed information for custom paper type or delete the custom paper type in [Paper Type Management Settings] in [Preferences] (Settings/Registration).

If you load tab paper:

Select [Tab 1] or [Tab 2] → press [No. of Tabs].

Specify the number of tabs → press [OK].

Select the same paper size as the one you loaded → press [OK] → [OK].

If you load standard size paper:

If you load custom size paper:

If you load standard size paper:

Select the paper from <A/B Size> → press [OK].

NOTE
To select an inch paper size, press [Inch Size].

If you load custom size paper:

Press [Custom Size].

Press [X] and [Y]→ enter each value→ press [OK].

NOTE
You can select a button ([S1] to [S5]) containing a stored paper size setting, instead of entering values.

Press [OK].

NOTE
You can also specify the paper type from the Status Monitor/Cancel screen. (See "Checking the Status of Consumables and Other Information.")