You can recall the three most recent destinations, scan settings, or send settings.

• The machine considers any one of the following operations a send job:

• When settings, such as the destination, scan settings, and send settings, are specified, and the control panel power switch, (Start) or (Reset) is pressed

• When the Auto Reset mode activates or after the Auto Sleep time has elapsed, after send settings are specified

• The Standard mode is not stored in Recent memory.

• Identical send settings are stored only once in Recall memory.

• If [Manage Address Book Access Numbers] is set to 'On', you cannot use previous settings. (See "Access Number Management.")

• If at least one type of destination is restricted in [Limit New Destination], the previous settings are deleted. (See "Restricting New Addresses.")

• The three most recent settings that were stored in memory are not deleted even when the main power is turned OFF.

• If the Preview mode is set, you can verify the images from the Preview screen before sending your document. (See "Preview.")

1. Place your originals → press [Previous Settings].

• For instructions on placing your originals, see "Basic Operations."

2. Select [History 1], [History 2], or [History 3] → confirm the settings → press [OK].

• You can change the settings in a recalled send job.

• If there are multiple destinations stored in one log, the order of the destinations shown in the list may not correspond to the order in which they were set.

• Back To Top