This mode enables you to interrupt the current job or a reserved job to make priority copies.

This mode is useful if you need to make a rush copy during a long copy job.

• For information on the modes which cannot be set in combination with this mode, see "Combination of Functions Chart."

• You cannot make interrupt copies if there is an interrupt copy job being processed or waiting to be processed.

• To cancel the Interrupt mode, press [Interrupt].

• To cancel previously set copy modes, press (Reset). (The Interrupt mode itself is not canceled.)

1. Press [Interrupt].

If you want to make copies after changing the Department ID while Department ID Management is enabled, press (Log In/Out) → enter the Department ID and PIN using - (numeric keys). (See "Security.")

• The current job does not stop printing immediately after you press [Interrupt]. Printing of the current job stops only when the actual printing of the priority or interrupt copy starts.

2. Place your originals → set the desired copy modes.

3. Press (Start).

4. Once the originals are scanned, remove them from the machine.

• If you want to continue making interrupt copies, wait until the current interrupt copy job is complete (end of printing). Then, repeat steps 1 to 4.

• Back To Top