Return to Overview

Connect the supplied telephone cable to the line jack (A) and the wall jack.

Connect your external telephone to the external device jack (B) if required.

• If you want to use an external telephone and receive faxes, you will need to set up the receiving mode. (See "Set the Machine for Receiving Faxes.")

1. Connect the power cord into the rear socket and the wall outlet and press the [I] side of the main power switch to ON.
   When restarting the machine, wait at least 10 seconds before turning the main power back on.

2. The machine enters standby mode.

The machine enters standby mode.

• <LEFT COVER OPEN / CLOSE COVER> is displayed:
  Make sure that the left cover is closed properly. (See "Install Toner Cartridge.")

• <TONER IS NOT SET / INSERT TONER> is displayed:
  Make sure that the toner cartridge is installed properly. (See "Install Toner Cartridge.")

• <TONER LOW / PREPARE NEW TONER> is displayed:
  If this message is displayed after a new toner cartridge has been set in place, reset the toner cartridge after shaking it slowly five, or six times. (See "Install Toner Cartridge.")

• Back To Top