e-ManualTopSite mapHelp

Category Top

Loading Paper

Loading Paper into a Paper Deck (Main Unit, POD Deck-D1 (Optional))

Adjusting a Paper Deck to Hold a Different Paper Size (Main Unit, POD Deck-D1 (Optional))

Loading Pre-Punched Paper

Loading Transparency/Clear/Translucent Film

Loading Tab Paper

Loading Paper into the POD Deck Lite-C1 (Optional)

Loading Paper into the LONG SHEET TRAY-A1 (Optional)

Loading Paper into the Document Insertion Unit-N1 (Optional)

Replacing the Staple Cartridge (For Optional Products)

Replacing the Staple Cartridge in the Stapler Unit (Finisher-AN1/Saddle Finisher-AN2)

Replacing the Staple Cartridge in the Saddle Stitcher Unit (Saddle Finisher-AN2)

Removing Staple Waste (Finisher-AN1/Saddle Finisher-AN2)

Removing Punch Waste (Puncher Unit-BS1/Puncher Unit-BT1)

Operating the Limited Functions Mode

Replacing Cleaning Web Unit

Replacing the Toner Cartridge

Replacing the Waste Toner Container

Routine Cleaning

Originals Cannot Be Scanned Properly (Cleaning the Platen Glass)

Originals Cannot Be Scanned Properly (Cleaning Method of the Original Scanning Area)

Scanned Originals Become Dirty (Manual Feeder Cleaning)

Scanned Originals Become Dirty (Automatic Feeder Cleaning)

Output Paper Becomes Dirty (Cleaning Inside of the Main Unit)

Output Paper Becomes Dirty (Wire Cleaning)

Output Paper Becomes Dirty (Roller Cleaning)

Streaks and Gloss Unevenness Appear on Output Paper (Refreshing the Fixing Roller)

Streaks and Gloss Unevenness Appear on Output Paper (Adjusting the Fixing Roller Auto Refresh Level)

Cleaning the Touch Panel Display

Consumables

Top » Maintenance » Routine Cleaning » Output Paper Becomes Dirty (Wire Cleaning)
Output Paper Becomes Dirty (Wire Cleaning)
0S9Y-091
If streaks appear on printed output or random parts of the printed image are missing, clean the corona assembly wires inside the main unit.
1.
Press (Settings/Registration).
2.
Press [Adjustment/Maintenance] → [Maintenance] → [Clean Wire].
3.
Press [Start].
It takes approximately 20 seconds to clean the wire.
When cleaning is complete, try printing again.
IMPORTANT
Do not turn the main power switch OFF or open the front covers while the machine is cleaning the wire.
NOTE
Wire cleaning cannot be performed during printing.
Back to Top