Return to Overview

1. Place your originals → press [Options] → [Finishing].

• If [Auto Collate] is set to 'On', the Collate or Offset Collate mode is automatically set when you place your originals in the feeder. (See "Auto Collate.")

2. Press [Group (Same pages)].

If you want to make hole punches, press [Hole Punch].

• If only the Professional Puncher-C1 is attached, the punch die name that is set in the Professional Puncher-C1 is displayed. Check that the displayed punch die is the one you want to use. If you want to use another punch die, see the instruction manual for the Professional Puncher-C1. (If you are using the imageRUNNER ADVANCE C9075 PRO/C9065 PRO)

• If you press [Hole Punch] with both the Puncher Unit-BF1 and Professional Puncher-C1 attached, [Finisher Puncher] and [Puncher Unit] with the punch die name that is set in the Professional Puncher-C1 are displayed. Select either of them → press [OK].

• If you want to replace the punch die that is set in the Professional Puncher-B1 with another punch die, see the instruction manual for the Professional Puncher-C1. (If you are using the imageRUNNER ADVANCE C9075 PRO/C9065 PRO)

If you want to fold, press [Fold] → select the fold type → press [OK].

If you want to select Face Up/Face Down, press [Face Up/Face Down].

• If you select [Rotate 90 Degrees]:

• If you select [Rotate 90 Degrees]:

• Press [Change] → select [LTR] or [LTRR] → press [OK].

• [Rotate 90 Degrees] can be selected only in the following cases:

• If the available paper size is selected manually

• If the available paper size is loaded in both the horizontal and vertical directions

• The selected paper source must have [Paper Drawer Auto Selection On/Off] set to 'On'. (See "Setting the Paper Drawer Auto Selection On/Off.")

• If there is no paper which can be rotated, the output will be collated.

3. Press [OK].

4. Press (Start).

• Back To Top