Starting/Stopping Applications

Starting Applications

Click [MEAP Application Management].

Application Name	Displays the name of the application.
Installed on	Displays the date on which the application was installed.
Status	Displays the status of the application.
License	Displays the license status of the application.
Resource Information	Displays the resources being used by the applications.

The types of application statuses are described below.

Message	Status
Installed	Application has been installed but not started, or the application has not been restarted after stopping the application and then restarting the machine.
Started	Application is running.
Stopped	Application is stopped.
Starting	Application is starting up.
Stopping	Application is closing down.

The types of license statuses are described below.

Message	Status
Installed	An effective license file has been installed.
Not Installed	License file is disabled.
Excess	Expiration date and the types of counters set for the installed license file, and any counter value(s) exceeding the upper limit of the license file.
Invalid	Installed license file has exceeded its expiration date. Alternatively, current counter value has exceeded the upper limit of the license file. (When a license file is set to many types of counters, it will expire when any counter exceeds the upper limit.)

Resource Information displays the resources being used by all applications.

Resource Information	Description	Timing of Update
Storage	Amount of hard disk space being used. Shown in kilobytes (KB).	When installing/uninstalling applications.
Memory	Amount of memory being used. Shown in kilobytes (KB).	When starting/stopping applications.
Threads	Number of threads.
Sockets	Number of sockets.
File Descriptors	Number of file descriptors.

Select the application you want to start → click [Start].

IMPORTANT
You cannot start applications whose required license file has not been installed. When the resources required for memory, threads, sockets, or file descriptors has run out, the application will not start, even if you click [Start].

Stopping Applications

To update an application, you must close the application you want to update.

Click [MEAP Application Management].

Select the application you want to stop → click [Stop].

NOTE
If you start/stop an application, you may need to restart the computer to activate the driver settings of USB devices. Follow the instructions on the screen and restart the computer.