Return to Overview

You have printed from Windows without installing the printer driver for Windows that was included with the machine.

Install the printer driver for Windows that was included with the machine and print the data again. (See Chapter 15, "Before Printing from Computers," in Getting Started.)

MS-DOS application software printer settings are incompatible.

Reset the MS-DOS application software printer settings on a printer that is compatible with the machine. (See the application software manual.)

The 'Send According to Font Substitution Table' setting has been set on the printer driver for Windows.

Set the 'Send According to Font Substitution Table' setting to the correct setting and print the data again. (See the Help function on the printer driver.)

The command that identifies the end of the data has not been sent from the computer
(The Processing/Data indicator is blinking or lit.)

Clear the print data. (If you print from application software that does not have a print function and the last page of data is not a full page, the data will remain in the machine's memory.)

The paper size you have specified is not supported by two-sided printing.

Change the print job settings and print the data again.

The settings for the front and back sides of the paper are different.

Change the print job settings and print the data again.

The paper is not in the correct position.

Make sure the machine is set correctly and try printing again. (See "Maintenance.")

The data is outside the printable area.

Insert margins around the data and print the data again. (See the Help function on the printer driver or the application software manual.)

Change the 'Scaling' settings on the printer driver and print the data again. (See the Help function on the printer driver.)

Margin, Offset Short Edge, or Offset Long Edge in the printer settings menu have been changed.

Set Margin, Offset Short Edge, and Offset Long Edge to '0.00' and print the data again. (See "Gutter," "Offset Short Edge/Offset Long Edge (Front)," and "Offset Short Edge/Offset Long Edge (Back).")

The application software's top margin and paper location settings are not correct.

Set the correct settings for the top margin and the paper location and print the data again. (See the application software manual.)

The application software's "Line spacing" and "Number of lines on a page" settings are not correct.

Change the settings so that the data fits on one page and print the data again.
(See the application software manual.)

The 'Timeout' setting is too short, when the 'Personality' setting is set to [Auto].

Change the 'Personality' setting to a setting other than [Auto], or increase the 'Timeout' setting. (See "Personality" and "Timeout.")

• Back To Top