Return to Overview

The position of the copy numbers specified with 'Print Position' can be finely adjusted by offsetting them in the horizontal or vertical directions. The adjustment can be made in increments of 1/16" from -5/16" through +5/16".

You can increase or decrease the setting value to adjust the print position of the copy numbers, as described below.

Number Position Vertical: Increasing the setting value moves the print position in the downward direction of the paper. Decreasing the setting value moves the print position in the upward direction of the paper.

Number Position Horizontal: Increasing the setting value moves the print position to the right. Decreasing the setting value moves the print position to the left.

• Please note that if the print position is adjusted to place the digits of the copy numbers outside the printable area, the portion outside the printable area is not printed.

• This setting is only effective for the print position of copy numbers. When adjusting print position (other than the copy numbers), perform the setting with 'Offset Short Edge/Offset Long Edge'. (See "Offset Short Edge/Offset Long Edge (Front)" and "Offset Short Edge/Offset Long Edge (Back).")

• This function is only available if 'Copy Set Numbering' is set to [On].

• Back To Top