Return to Overview

• Insertion Unit

If the Add Cover, Insert Sheets, Job Separator, or Booklet mode is set, you can use the paper loaded in the document insertion unit as a cover. If the Document Insertion/Folding Unit-G1/Document Insertion Unit-J1 is attached to the finisher, you can use paper different to the main document pages for a cover.

• This section assumes that the Document Insertion/Folding Unit-G1 or Document Insertion Unit-J1 is attached to the Staple Finishder-B1 or Booklet Finisher-B1.

• Paper which has been rolled or curled must be straightened out before placing it into the document insertion unit.

• Do not place the following types of paper into the document insertion unit. Doing so may cause a paper jam.

• Insertion sheets with holes or tears

• Severely curled or wrinkled paper

• Clipped or stapled insertion sheets

• Transparencies or other highly transparent insertion sheets

• Tracing paper

• Labels

• Document Insertion Unit Staple Settings and Output Results Table

How to Place the Cover Sheet/Original			Staple Settings	Output Result
Document Insertion Unit	Feeder	Platen Glass
			Corner: Upper Left Double: Left	LTR
			Corner: Lower Left Double: Left	11" × 17" LGL 11" × 17"
			Corner: Upper Right Double: Right
			Corner: Lower Left Double: Left	LTR
			Corner: Upper Right Double: Right
			Corner: Upper Left Double: Left	11" × 17" LGL 11" × 17"
			Corner: Upper Right Double: Right	LTR
			Corner: Upper Left	11" × 17", LGL
			Corner: Lower Right
			Corner: Upper Left	LTR
			Corner: Lower Right
			Corner: Upper Right Double: Right	11" × 17" LGL 11" × 17"
			Saddle Stitch

• For instructions on loading paper into the Document Insertion/Folding Unit-G1/Document Insertion Unit-J1, see "Maintenance."

• Back To Top