Return to Overview

When the Staple Finisher-B1/Booklet Finisher-B1 is almost out of staples and the staple cartridge in the stapler unit must be replaced, a screen prompting you to replace the staple cartridge appears on the touch panel display. Follow the procedure described below to replace the staple cartridge.

Use only staple cartridges intended for use with this machine. See "Optional Products Required for Each Function (imageRUNNER ADVANCE C7065/C7055)."

• We recommend that you order staple cartridges from your local authorized Canon dealer before your stock runs out.

• Remove the orange seal that holds the staples together after you place the staple cartridge into the staple case.

1. Open the front cover of the finisher.

2. Lift and pull out the staple case from the stapler unit, holding it by its green tab.

3. Press the area indicated by PUSH, and then lift up the staple cartridge.

4. Pull out the staple cartridge.

5. Insert the new staple cartridge.

Press the spring-loaded case down until it clicks into place.

• Use only cartridges intended for use with this machine.

• Do not remove the seal that holds staples together before you place the staple cartridge into the staple case.

• Only one staple cartridge can be inserted at a time.

6. Remove the seal holding the staples together, by pulling it straight out, and then down.

• Make sure that you pull the seal straight out, and then down. If you pull it out at an angle, it may tear.

7. Gently push the staple case into the stapler unit, until it is securely in place.

8. Close the front cover of the finisher.

• When closing the front cover of the finisher, be careful not to get your fingers caught, as this may result in personal injury.

• If there are no staples ready for stapling after the cover is closed, the stapler unit automatically performs a "dry" stapling operation to reposition the staples.

• Back To Top