Return to Overview

When the punch waste tray of the Puncher Unit-BF1 becomes full, a screen prompting you to remove the punch waste appears on the touch panel display. Follow the procedure described below to remove the punch waste.

• Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple cartridge, discard the punch waste, discard the trim waste, or clear paper or staple jams, prints may still be output if other optional units are operating normally, and are not involved in the paper or staple jam removal procedure.

• When the punch waste tray is full, you cannot make copies or prints using the Hole Punch mode.

• This procedure is necessary only if the Puncher Unit-BF1 is attached.

1. Open the front cover of the finisher.

2. Pull out the punch waste tray.

3. Discard the punch waste into a receptacle.

• Make sure that the punch waste tray is completely emptied.

4. Return the punch waste tray to its original position.

Always make sure to insert the punch waste tray far as it can go.

• If the punch waste tray is not securely in place, you cannot make copies or prints in the Hole Punch mode.

5. Close the front cover of the finisher.

• When closing the front cover of the finisher, be careful not to get your fingers caught, as this may result in personal injury.

• Back To Top