Return to Overview

When the trim waste tray of the Inner Booklet Trimmer-A1 becomes full, a screen prompting you to remove the trim waste appears on the touch panel display. Follow the procedure described below to remove the trim waste.

• Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple cartridge, discard the punch waste, discard the trim waste, or clear paper or staple jams, prints may still be output if other optional units are operating normally, and are not involved in the paper or staple jam removal procedure.

• When the trim waste tray is full, you cannot make copies or prints using the Trim mode.

• This procedure is necessary only if the Inner Booklet Trimmer-A1 is attached to the Booklet Finisher-A1.

1. Open the front cover of the finisher.

2. Pull out the trim waste tray.

3. Discard the trim waste into a receptacle.

• Make sure that the trim waste tray is completely emptied.

4. Return the trim waste tray to its original position.

Always make sure to insert the trim waste tray far as it can go.

5. Close the front cover of the finisher.

• When closing the front cover of the finisher, be careful not to get your fingers caught, as this may result in personal injury.

• Back To Top