Maintenance > Staple Finisher-A1/Booklet Finisher-A1/Puncher Unit-BF1/Inner Booklet Trimmer-A1 (Optional) > Replacing the Staple Cartridge in the Stapler Unit
*
Replacing the Staple Cartridge in the Stapler Unit

Return to Overview

When the Staple Finisher-A1/Booklet Finisher-A1 is almost out of staples and the staple cartridge in the stapler unit must be replaced, a screen prompting you to replace the staple cartridge appears on the touch panel display. Follow the procedure described below to replace the staple cartridge.

Use only staple cartridges intended for use in this machine. See "Optional Products Required for Each Function (imageRUNNER ADVANCE C9075 PRO/C9065 PRO)."

Remark
  • Take care when handling the optional equipment that is attached to the machine. When an optional unit's cover is opened to replace a staple cartridge, discard the punch waste, discard the trim waste or clear paper or staple jams, prints may still be output if other optional units are operating normally, and are not involved in the paper or staple jam removal procedure.
  • We recommend that you order staple cartridges from your local authorized Canon dealer before your stock runs out.
  • Remove the orange seal that holds the staples together after you place the staple cartridge into the staple case.

  1. Open the front cover of the finisher.
  1. Pull out the staple case from the stapler unit, holding it by its green tab.
  1. Turn over the staple case, and open the cover while pressing PUSH on both sides of the staple case.

  • Align the staple case as indicated in the diagram.
  • The cover will not open if there are any staples remaining, even if you press PUSH on both sides of the staple case.
  1. Remove the staple case by pulling it out.

  1. Insert the new staple case.
  1. Remove the white seal fixing the staples by pulling it straight out.

  • Make sure that you pull the seal straight out. If you pull it out at an angle, it may tear.
  1. Close the staple case cover.
  1. Gently push the staple case into the stapler unit, until it is securely in place.

Always make sure to insert the staple case far as it can go.
  1. Close the front cover of the finisher.

  • When closing the front cover of the finisher, be careful not to get your fingers caught, as this may result in personal injury.

  • Back To Top