Maintenance > Document Insertion Unit-H1 (Optional) > Loading Paper
*
Loading Paper

Return to Overview

This section describes the procedure for feeding sheets using the Document Insertion Unit-H1.

  1. Adjust the slide guides to fit the paper size.
  • To use the upper tray:
  • To use the lower tray:

  • To use the upper tray:
  • Adjust the slide guide.

  • To use the lower tray:
  • Open the tray cover.
  • Adjust the slide guide.

  1. Open a package of paper, and remove the paper stack.
  • When loading paper, take care not to cut your hands on the edges of the paper.
  • Rewrap any remaining paper in its original package, and store it in a dry place, away from direct sunlight.
  • For instructions on loading tab paper into the paper deck, see "Loading Tab Paper."
  • For high-quality printouts, use paper recommended by Canon.
  • Before loading paper, always fan the sheets several times, and align the edges to facilitate feeding. Also, you should always fan paper that has just been removed from a newly opened paper package.
  1. Load the paper stack into the Document Insertion Unit.
  • Make sure that the height of the paper stack does not exceed the loading limit mark () at the back of the paper supply tray.
  • You cannot make copies or prints on paper that is loaded in the document insertion unit.
  • You can load 13" × 19", 12 5/8" × 17 11/16", 12" × 18", 11" × 17", LGL, LTR, LTRR, EXEC, and custom size (7 1/8" × 7 1/8" to 13" × 19 1/4" (182.0 mm × 182.0 mm to 330.2 mm × 487.7 mm)) into the trays of the Document Insertion Unit.
  • A maximum of 200 sheets of paper (20 lb bond (80 g/m2)) can be loaded in the trays of the Document Insertion Unit.
  • If you want to load paper into the upper tray:
  • If you want to load paper into the lower tray:

  • If you want to load paper into the upper tray:
  • Load the paper face up.

  • If you want to load paper into the lower tray:
  • Load the paper face up.
  • Close the tray cover.
  1. Select the desired paper size → press [Next].

  • Select the same paper size that is loaded in the Document Insertion Unit.
  • To select an A or B series paper size, press [A/B-size].
  1. Select the desired paper type → press [OK].

  • Back To Top