Return to Overview

If an error occurs while a job is being carried out, an error code appears in Details on the Status Monitor/Cancel screen, and is included in various reports such as the Communication Management Report.

Error Code	Cause	Remedy
#701	The specified Department ID did not exist when the job was executed. Or, the password was changed.	Enter the correct Department ID or PIN using - (numeric keys) on the control panel, and then try sending again.
	The Department ID or PIN was changed during the job.	Try performing the job again with the new Department ID and PIN. If you do not know the PIN, contact your system administrator.
	[Allow Printer Jobs With Unknown IDs] is set to 'Off'.	Set [Allow Printer Jobs with Unknown IDs] to 'On' in [Department ID Management] in [Management Settings] (Settings/Registration). Follow the procedures below. Press (Settings/Registration) → [Management Settings] → [Department ID Management] → [Allow Printer Jobs with Unknown IDs].
#853	The job could not be executed when you tried to print a large number of pages on the printer, due to insufficient resources.	Reduce the number of pages to print, or execute the job again when there are no other print jobs reserved.
	When sending print data to the machine from a computer, the job could not be executed because it was canceled from the printer driver.	Perform the operation again.
	The spool region for the received data became full and all the data from the host could not be spooled with [Use Spool Function] set to 'On' in Network Settings in Preferences (Settings/Registration).	Set [Use Spool Function] to 'Off' in [Network Settings] in [Preferences] (Settings/Registration), and perform the operation again. Follow the procedures below. Press (Settings/Registration) → [Preferences] → [Network] → [Use Spool Function].
	The maximum received data size was exceeded when processing the received data.	Perform printing again when all the jobs are complete. If you still cannot perform printing, check the sent data.
	The maximum number of secure print jobs that can be received at the same time was exceeded.	Execute or erase secure print jobs stored in the machine, and perform the operation again. Follow the procedures below to check the secure print jobs stored in the machine. Press (Status Monitor/Cancel) → [Copy/Print] → [Job Status].

• Back To Top