Return to Overview
This section describes how to set TX reports to print automatically. The default setting is <PRINT ERROR ONLY>.
The following items are printed in a TX REPORT:
- REPORT NAME: When the document transmission is completed successfully, a "TX Report" is printed. When a send error occurs, an "Error TX Report" is printed.
- TX/RX NO: Transaction number
- DEPT. ID: If Department ID Management is set, the Department ID is printed.
- RECIPIENT ADDRESS: Destination number or address
- DESTINATION ID: Destination name registered in the Address Book
- ST. TIME: Transmission start time
- TIME USE: Transmission duration
- PAGES SENT: Number of pages sent
- RESULT: Result of transaction
- OK: Transmission successful
- STOP: Transmission manually canceled before completion
- BUSY/NO SIGNAL: The line is busy or the recipient does not answer your call
|