|
|
|
|
|
- To print on the back side of preprinted paper:
- Load the preprinted paper face up into the stack bypass, as shown in the illustration below.
- When the paper is loaded into the stack bypass, the side facing down is the one printed on.
The screen for selecting the paper size appears.
- Make sure that the paper stack does not exceed the paper limit guide.
- Some types of paper may not feed properly into the stack bypass. For high quality copies, be sure to use the paper and transparencies recommended by Canon.
- When making copies of a small document or thick paper, etc., the copy speed may be slightly slower than usual.
- If there are instructions on the paper package about which side of the paper to load, follow those instructions.
- If problems, such as poor print quality or paper jams occur, try turning the paper stack over and reload it.
|