Return to Overview

The left cover is open.

Check the left cover and make sure that it is completely closed.

The size of the paper in the paper cassette or multipurpose tray is different from that of the paper specified in <CASSETTE> or <MP TRAY> of the <PAPER SETTINGS> menu.

Load the correct size paper or change the paper size in <CASSETTE> or <MP TRAY> of the <PAPER SETTINGS> menu. For more information, see "If <LOAD CORRECT PAPER> is displayed."

No paper is loaded in the paper cassette or multipurpose tray when copying or printing.

Load the paper correctly by inserting it all the way to the back of the paper cassette.

If the paper size is not appropriate for printing, an error message appears with one of the messages below.
<CHANGE REG'D SIZE → PAPER SETTINGS> or <CANNOT PRINT RX DATA/FIX ERROR TO PRINT>

Set the appropriatesize paper for printing, and specify the correct size of paper in <PAPER SETTINGS>. For printing reports or lists, set the paper size to <LTR>, <LGL>, <A4>, <OFICIO>, <BRAZIL-OFICIO>, <MEXICO-OFICIO>, <FOLIO>, <GOVERNMENT-LETTER>, <GOVERNMENT-LEGAL> or <FLSP>, and then load paper of the same size.

The appropriate paper for printing is not loaded.

After setting the appropriatesize paper for printing, specify the correct size of paper in the <PAPER SETTINGS> menu.

The machine is full of jobs.

Print, send, or delete any documents stored in memory.

Divide the document stack or data into a few parts and try again one by one.

Send the document with low resolution.

When this message appears during using the ADF, the scanning document stops halfway. In this case, clear the paper jam from the ADF.

The number of TX/RX jobs that can be stored in memory reached the maximum.

The maximum numbers of jobs that can be stored in memory are as follows (Based on the condition that the other party sends the fax by the LASER CLASS 810/LASER CLASS 830i with ITU-T No. 1 Chart standard mode);
Up to 70 jobs for sending or 90 jobs for receiving, 95 fax jobs including sending and receiving, or 75 e-mail and I-fax jobs for receiving.
Wait for the machine to send any documents in memory. Also print, send, or delete any documents stored in memory.

You have specified the group dialing when the line is off the hook.

Specify the recipient other than group dialing.

You have specified the one-touch key or coded dial code that has registered with other than fax number when the line is off the hook.

Make sure that the line is disconnected.

The registered group is already nested for three levels of subgroups (e.g., a group registered in a group in a group in a group).

You cannot register a group to contain more than three levels of subgroups. Modify the group so that it contains three levels of groups or less.

You pressed the one-touch key or coded dial code that has already been registered, when you are registering group addresses.

You pressed the group dialing that has already been registered, when you are registering a one-touch or coded dial address.

Register the one-touch key or coded dial code that is not used.

No destination is registered for the one-touch key or coded dial code you pressed.

Register the destinations before using the Address Book function.

No paper is loaded in the recipients fax machine.

Have the recipient reload their fax machine with paper.

The paper delivery tray is full of paper.

Remove the printouts from the paper delivery tray.

You cannot print because the set page limit for either scans, prints, or copies in the department ID management function has been reached.

Contact your system manager.

• Back To Top