*
 
Ethernet Driver

Return to Overview

You can specify the communication method and Ethernet connection type.
Remark
  • To set the machine to a network with the LASER CLASS 810, an optional network printer kit is required.

 
     
  1. Press [Additional Functions].
 
     
  1. Press [] or [] to select <SYSTEM SETTINGS>, then press [OK].

If the System Manager ID and System Password have been set, enter the System Manager ID and System Password using the numeric keys, then press [Log In/Out (ID)].
 
     
  1. Press [] or [] to select <NETWORK SETTINGS>, then press [OK].
 
     
  1. Press [] or [] to select <ETHERNET DRIVER>, then press [OK].
 
     
  1. Confirm that <AUTO DETECT> is displayed, then press [OK].
 
     
  1. Press [] or [] to select the desired detection method, then press [OK].
<AUTO>: Automatically determines the communication mode (Half duplex/Full duplex) and Ethernet type (10Base-T/100BaseTX). Skip to step 11.
<MANUAL>: You have to manually specify the communication mode and Ethernet type.
  • If you reconnect the network cable (for example, reconnect the cable to a different Ethernet hub) with the power on, the Auto Detect function will not work even if you set <AUTO DETECT> to <AUTO>. (Connect the cable with the power off.)
 
     
  1. Press [] or [] to select <COMMUNICATION MODE>, then press [OK].
 
     
  1. Press [] or [] to select the desired communication method, then press [OK].
<HALF DUPLEX>: Sends and receives alternately.
<FULL DUPLEX>: Sends and receives simultaneously.
 
     
  1. Press [] or [] to select <ETHERNET TYPE>, then press [OK].
 
     
  1. Press [] or [] to select the desired Ethernet connection type, then press [OK].
<10 BASE-T>: Establish a 10Base-T network connection.
<100 BASE-TX>: Establish a 100Base-TX network connection.
 
     
  1. Press [Stop] to return to the standby mode.
 
       
  1. Restart the machine.

Turn off the machine, wait at least 10 seconds, and then, turn it on.

 
  • Back To Top