Return to Overview

1. Open the left cover.

2. Grasp the blue plastic pull tab (A) on the toner cartridge.

3. Pull the blue plastic pull tab until you can easily hold the handle of the toner cartridge.

4. Remove the toner cartridge.

• Always hold the toner cartridge by its handle.

• Do not open the drum protective shutter on the toner cartridge. Print quality may deteriorate if the drum surface is exposed to light or is damaged.

5. Remove the new toner cartridge from the protective material.

6. Gently rock the toner cartridge 5 or 6 times to distribute toner evenly.

7. Remove the seals (2 places).

8. Bend back the blue plastic pull tab.

• Do not remove the pull tab as it is used to pull out the toner when the cartridge needs replaced.

9. Pull out the seal completely.

• Do not pull out the seal at an angle.

10. Hold the toner cartridge by its handle.

The arrows (A) on the toner cartridge should be pointing toward the machine.

11. Insert the toner cartridge into the machine as far as it will go.

The left edge (A) and the right side protrusions (B, C) of the toner cartridge should be aligned with the guides inside the machine.

12. Push the toner cartridge to make sure it is properly set in the machine.

• Do not touch the fixing assembly (A) as it becomes very hot during use.

13. Close the left cover.

• Be careful not to get your fingers caught.

• If you cannot close the left cover, do not force it to close. Open the cover and make sure the toner cartridge is properly set in the machine.

• Back To Top