Return to Overview

Keep the scanning area clean to avoid dirty copies or faxes to be sent.

If your documents have black streaks or appear dirty after copying them using the ADF, this may be caused by pencil lead rubbing off the documents and onto the roller. Clean the ADF scanning area, film, and roller.

1. Turn off the main power switch and disconnect the power cord.

2. Lift the lever, and open the ADF cover.

3. Open the feeder front cover.

4. Clean the rollers (A) inside the ADF with a cloth dampened with water. Then wipe the area with a soft, dry cloth.

• Do not dampen the cloth too much, as this may tear the document or damage the machine.

5. Clean the narrow glass plate (B) and the white plate (C) with a cloth dampened with water. Then wipe the area with a soft, dry cloth.

• Do not push on the white plate hard. The white plate is a soft, delicate area.

• Do not dampen the cloth too much, as this may tear the document or damage the machine.

6. Lift the document feeder tray.

7. Clean the rollers (D) below the document feeder tray with a cloth dampened with water. Then wipe the area with a soft, dry cloth.

8. Lower the document feeder tray.

• Be careful not to get your fingers caught.

9. Close the ADF.

• Be careful not to get your fingers caught.

10. Reconnect the power cord and turn on the main power switch. Cleaning the ADF Automatically.

• Back To Top