Double Staple Width Adjustment
You can adjust the double staple width.
This mode can be set when the Finisher-AN1 or Saddle Finisher-AN2 is attached. (See "Finisher-AN1/Saddle Finisher-AN2/Puncher Unit-BS1/Puncher Unit-BT1.")
NOTE
This item is only valid [Offset] is not set.
1.
Press (Settings/Registration).
2.
Press [Adjustment/Maintenance] → [Adjust Action] → [Adjust Double Staple Width].
3.
Press [-] or [+] to adjust the staple width → [OK].
» Adjustment for Image Quality and Finishing (Calibration) » Adjust Action » Double Staple Width Adjustment
0S9Y-079