Changing the Finisher Output Priority Settings (Thin)

When Thin paper 2 is used, you can give a priority to productivity or alignment for the output paper.

This mode can be set when the Finisher-AM1 or Saddle Finisher-AM2 is attached. (See "Finisher-AM1/Saddle Finisher-AM2/Puncher Unit-BS1/Puncher Unit-BT1.")

Press

(Settings/Registration).

Press [Adjustment/Maintenance] → [Adjust Action] → [Finisher Output Priority Settings (Thin)].

Select [Productivity Priority] or [Alignment Priority] → press [OK].

Details of each item are shown below:

[Productivity Priority]	This mode gives a priority to productivity. The output paper may not be aligned.
[Alignment Priority]	As a priority is given to aligning the output paper, the production speed decreases compared with [Productivity Priority] mode.

NOTE
[Alignment Priority] is available only when outputting on Tray B of a finisher.