High Volume Stack Mode
If your machine has multiple output trays, and is equipped with a finisher, you can fix the tray designation settings.
This mode can be set when the Finisher-AM1 or Saddle Finisher-AM2 is attached. (See "Finisher-AM1/Saddle Finisher-AM2/Puncher Unit-BS1/Puncher Unit-BT1.")
1.
Press (Settings/Registration).
2.
Press [Function Settings] → [Common] → [Paper Output Settings].
3.
Press [High Volume Stack Mode].
4.
Press [On] → [OK].
Select [Off] if you do not want to enable the High Volume Stack mode.
If High Volume Stack mode is set to [On], the tray order to which prints are output is fixed as follows:
Tray B → Tray A.

NOTE
If the Booklet Trimmer-D1 is attached, the [High Volume Stack Mode] is not available.
The [High Volume Stack Mode] cannot be set while you are copying or printing.
If the Limited Functions Mode for a finisher is set to 'On', the High Volume Stack mode is not available.
If a Finishing mode is set, the output trays move downward as the stack of paper that is output increases in quantity and thickness. Once an output tray has reached its stacking limit, subsequent prints are automatically delivered to the next available tray. If all of the available trays have reached their stacking limits, printing stops temporarily. Remove all of the output paper from the trays. The trays move upward, and printing resumes.
» Settings/Registration » Function Settings » Common » Paper Output Settings » High Volume Stack Mode
0L3X-07K