Specifying Paper Drawer Auto Selection Based on Color

You can specify [Color] or [B&W] settings to each paper source in order to select the paper source automatically according to the color mode selected when copying.

If you register the paper type for each paper source beforehand, paper type can be selected according to the color mode. For more information on registering the paper type for each paper source, see "Registering the Paper Size and Type for a Paper Source."

IMPORTANT
This function is only valid when operating Copy function.

NOTE
To use this function, set [Consider Color] for [Copy] to 'On' in [Paper Drawer Auto Selection On/Off] in [Function Settings] (Settings/Registration). (See "Enabling Paper Drawer Auto Selection.")

Press

(Settings/Registration).

Press [Function Settings] → [Common] → [Paper Feed Settings].

Press [Paper Drawer Auto Selection Based on Color].

Select [Color] or [B&W] for each paper source → press [OK].

[Color]:	Paper sources with [Color] setting are used if you select [Auto (Color/B&W)], [Full Color], [Single Color], or [Two Colors] in [Select Color] when copying.
[B&W]:	Paper sources with [B&W] setting are used if you select [B&W] in [Select Color] when copying.

Each button represents the following paper sources:

The POD Deck Lite-B1 and Stack Bypass-B1 are attached.

: Stack Bypass-B1

: Upper Paper Drawer

: Middle Paper Drawer

: Lower Paper Drawer

: POD Deck Lite-B1

The Multi-drawer Paper Deck-B1 is attached.

: Upper Paper Drawer

: Middle Paper Drawer

: Lower Paper Drawer

: Upper Paper Deck of the Multi-drawer Paper Deck-B1

: Middle Paper deck of the Multi-drawer Paper Deck-B1

: Lower Paper Deck of the Multi-drawer Paper Deck-B1

NOTE
In the following cases, the paper source which is set to [Color] is automatically selected regardless of the color mode specified when copying. When the Merge Job Blocks mode is set When both the Different Size Originals mode and the Job Build mode is set