To use the functions of the options (paper drawers, finisher, etc.) attached to the device, you must configure the option settings in the driver. Follow the procedure below to check and set the options.
IMPORTANT
|
Depending on the device you are using, the followings is required:
TCP/IP Protocol
Log on to the computer as a member of Administrators.
|
NOTE
|
The option settings are normally configured automatically when you install the driver. If you add options afterward, and the settings are not automatically updated, follow the procedure below.
|
1.
Select [Devices and Printers] from the [

] (Start) menu.
If you are using Windows 8/Server 2012, from the desktop, display the charm bar to the right of the screen, and select [

Settings] - [Control Panel] - [Devices and Printers].
If you are using Windows Vista, select [Control Panel] - [Printers] from the [

] (Start) menu.
2.
Right-click the icon for your device → click [Printer properties] (or [Properties]).
3.
Click the [Device] sheet → check the get device information status.
[Auto]: Gets the device status when installing and automatically sets the options. Check the settings and click [OK] to finish.
[Manual]: You cannot get the device status. Go to step 4 and set the options.
NOTE
|
If the device configuration is set automatically, you must set WSD print to ON at the device beforehand. For details, refer to the manuals provided with the device.
|
4.
Click [Get device information].
5.
Click [Yes] in the message box.
The detected information is displayed in the [Device] sheet.
If the device status is displayed: The options have been automatically set. Check the settings and click[OK].
If the device status is not displayed: Set the options manually. Select the options that are attached to the device and click [OK].
NOTE
|
If you are using a local printer (connected to a USB port, etc.), you cannot set up the printer configuration automatically.
|