Logging In to the User Management Page - Canon imageRUNNER ADVANCE C9280 PRO/C9270 PRO/C7270/C7260 e-Manual

Logging In to the User Management Page

To specify each setting for [User Access Control for Advanced Box], it is necessary to access and then log in to the machine from a Web browser. This section describes the procedure for accessing the machine from the portal page of the Remote UI.

IMPORTANT
Only the Advanced Box administrator can register a user. The following are the default settings for the user name and password for the Advanced Box administrator. We recommend that you change both the user name and password. User Name: Administrator Password: password To use [User Access Control for Advanced Box], set [Use HTTP] in [Preferences] (Settings/Registration) to 'On.' (See "Settings Common to TCP/IPv4 and TCP/IPv6.") To use the Remote UI, set [Remote UI] in [Management Settings] (Settings/Registration) to 'On'. (See "Remote UI.")

IMPORTANT

Only the Advanced Box administrator can register a user. The following are the default settings for the user name and password for the Advanced Box administrator. We recommend that you change both the user name and password.

User Name: Administrator

Password: password

To use [User Access Control for Advanced Box], set [Use HTTP] in [Preferences] (Settings/Registration) to 'On.' (See "Settings Common to TCP/IPv4 and TCP/IPv6.")

To use the Remote UI, set [Remote UI] in [Management Settings] (Settings/Registration) to 'On'. (See "Remote UI.")

Start your Web browser → enter the following URL in the address bar.

http://<IP address of the machine or host name>

NOTE
You can also log in by entering the URL of [User Access Control for Advanced Box] in the address bar, as indicated below. (Case sensitive.) http://<IP address or host name of the machine>:8000/uactrl/

If you are logging in as an administrator, select [System Manager Mode] → enter the System Manager ID and System Manager PIN → click [Log In]. If you are a general user, select [General User Mode] → enter PIN → click [Log In].

If the Department ID Management or authentication for SSO-H is set, enter the necessary items for each log in.

Click [User Access Control for Advanced Box] from the Basic Tools.

Enter the user name and password for Advanced Box administrator → click [Log In].

IMPORTANT
The following are the default settings for the user name and password for the Advanced Box administrator. We recommend that you change both the user name and password. User Name: Administrator Password: password

NOTE
Click [Log Out from User Access Control] to finish the operation. If you close the Web browser page without clicking [Log Out from User Access Control], the logout process will not be performed correctly. In this case, note that you will not be able to log in again for approximately 30 minutes.