Using the Multi-Purpose Tray |
Reserved printing using the multi-purpose tray is possible only if paper is being fed from the multi-purpose tray for the current job. The following example assumes that 11" × 17" plain paper is being fed from the multi-purpose tray for the current job, and that you are selecting LTR plain paper to be fed from the multi-purpose tray for a reserved job. |
Remark |
|
|
|||||
|
Normally, when reserved printing is not being set, the Multi-Purpose Tray Settings screen is automatically displayed when paper is loaded into the multi-purpose tray. |
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are printing on the back side of a previously printed sheet, press [2nd Side of 2-Sided Page].
|
|
|
|
You can also press a size key in which a paper size is registered ([S1] to [S5]), instead of entering a value.
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are printing on the back side of a previously printed sheet, press [2nd Side of 2-Sided Page]. |
|
|
The paper size/type currently loaded and the paper size/type reserved to be loaded are displayed, as shown on the screen below.
|
This completes the settings for reserving a print job using the multi-purpose tray. The subsequent steps show you how to start printing and load paper into the multi-purpose tray. |
|
|
If a message screen indicating that the width of the slide guides does not match the selected paper size is displayed, adjust the width of the slide guides → specify the paper size → press [OK]. If a message screen indicating that the width of the slide guides does not match the paper size registered in Multi-Purpose Tray Defaults is displayed, set [Register Multi-Purpose Tray Defaults] to 'Off'. (See "Registering Multi-Purpose Tray Defaults.")
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are printing on the back side of a previously printed sheet, press [2nd Side of 2-Sided Page]. |
|
|
|
You can also press a size key in which a paper size is registered ([S1] to [S5]), instead of entering a value.
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are printing on the back side of a previously printed sheet, press [2nd Side of 2-Sided Page]. |
|
|
|