Using the Multi-Purpose Tray |
You can perform reserved copying from the multi-purpose tray by specifying in advance the paper to be loaded for the next job. However, this is possible only if paper is being fed from the multi-purpose tray for the current job. The following example assumes that LTR plain paper is being fed from the multi-purpose tray for the current job, and that you are selecting 11" × 17" plain paper to be fed from the multi-purpose tray for a reserved job. |
Remark |
|
|
|||||
If the job displayed on the touch panel display is from a function other than the Copy function, press [Close] → (Main Menu) → [Copy] to display the Regular Copy Basic Features screen. |
Normally, when reserved copying is not being set, the Change MP Tray Paper screen is automatically displayed when paper is loaded into the multi-purpose tray. |
The paper size/type currently loaded and the paper size/type reserved to be loaded are displayed, as shown on the screen below.
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are copying onto the back side of a previously printed sheet, press [2nd Side of 2-Sided Page].
|
|
|
|
You can also press a size key in which a paper size is registered ([S1] to [S5]), instead of entering a value.
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are copying onto the back side of a previously printed sheet, press [2nd Side of 2-Sided Page]. |
|
|
|
This completes the settings for a reserved copy job using the multi-purpose tray. The subsequent steps show you how to load paper into the multi-purpose tray and complete the scanning and printing process of the reserved job. |
|
|
If the following screen is displayed, adjust the width of the slide guides → specify the paper size → press [OK]. If the following screen is displayed, adjust the width of the slide guides to match the paper size stored in [Register Multi-Purpose Tray Defaults], or set [Register Multi-Purpose Tray Defaults] to 'Off'. (See "Registering Multi-Purpose Tray Defaults.")
|
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are copying onto the back side of a previously printed sheet, press [2nd Side of 2-Sided Page]. |
|
If the desired paper type is not displayed, press [Detailed Settings] → select the paper type from the list → press [OK]. If you are copying onto the back side of a previously printed sheet, press [2nd Side of 2-Sided Page]. |
|
|
|