Before Using the WSD Scan

To use the WSD Scan function, you must specify the following settings:

NOTE
If you change the network settings, you need to restart the machine. After specifying the network settings, turn OFF the main power of the machine, wait at least 10 seconds, and then turn it ON. (See "Main Power and Energy Saver Key.")

Connect a computer to a same domain as the machine

Set [Use WSD Scan Function] to 'On'

1.	Press (Settings/Registration).
2.	Press [Preferences] → [Network] → [TCP/IP Settings].
3.	Press [WSD Settings].
4.	Press [On] for <Use WSD Scan Function>.

5.	Press [OK] → [Close].

Install a driver which supports WSD Scan functions

1.	Click (Start) → [Devices and Printers].

2.	Click [Add a device].

3.	Select this machine from the displayed list → click [Next].

IMPORTANT
If the firewall setting is set to 'On', this machine may not be displayed. In this case, set the firewall setting to 'Off'. You cannot use the WSD Scan functions in the following cases When the ACCESS MANAGEMENT SYSTEM is activated When the imagePASS or ColorPASS is used Scanning from a feeder may stop due to the internal operations of the Windows operating system. In this case, wait for a while and try again.

IMPORTANT

If the firewall setting is set to 'On', this machine may not be displayed. In this case, set the firewall setting to 'Off'.

You cannot use the WSD Scan functions in the following cases

When the ACCESS MANAGEMENT SYSTEM is activated

When the imagePASS or ColorPASS is used

Scanning from a feeder may stop due to the internal operations of the Windows operating system. In this case, wait for a while and try again.