Cleaning the Dust Proof Glass
If the dust proof glass is dirty, print defects may occur on the print output. Follow the procedure described below to clean the dust proof glass.
1.
Open the front cover, holding both sides.
2.
Remove the dust proof glass cleaner from the rear side of the front cover by sliding it to the left side.
* Dust Proof Glass Cleaner
3.
Hold the dust proof glass cleaner so that the pad on the tip is facing down, push it back as far as it goes, and then slowly move it up and down.
Clean the four locations as shown below. There are marks on the main unit that indicate the cleaning locations. Check these marks when cleaning the dust proof glass.
4.
When you have finished cleaning the dust proof glass, gently push the dust proof glass cleaner back onto the rear side of the front cover.
Place the dust proof glass cleaner back on the rear side of the front cover with its tip facing the left direction.
5.
Close the front cover of the main unit.
 CAUTION |
|
When closing the front cover of the main unit, be careful not to get your fingers caught, as this may result in personal injury.
|
