Specifying/Registering Scan Sizes
You can specify the standard size of the original. You can also register a custom size.
As an example, the procedure for selecting memory media as the storage location is explained in this section.
1.
Press [Scan and Store] → [Memory Media].
2.
Select the memory media → select the destination folder → press [Scan].
3.
Press [Scan Size] → select a scan size.
To specify a preset scan size:
Select the scan size you want to specify from the preset scan sizes.
To specify a scan size by entering values:
Press [Custom].
Press [X] or [Y] → enter the scan size in inch → press [OK].
Platen Glass
* Scanning Area
To select a registered scan size:
Press [Custom] → select [Registered Size 1] or [Registered Size 2] → press [OK].
4.
Press [OK].
1.
Press [Scan and Store] → [Memory Media].
2.
Select the memory media → select the destination folder → press [Scan].
3.
Press [Scan Size] → [Custom].
4.
Press [Register Size] → [Registered Size 1] or [Registered Size 2].
5.
Press [X] or [Y] → enter the scan size in inch.
6.
Press [OK] → [Cancel Set.] → [OK].
IMPORTANT
|
Place your original on the platen glass when [Custom] is set for the scan size.
|