Machine Settings
> Settings Menu
> ADJUST./CLEANING
ADJUST./CLEANING |
Setting Item | Description | Applicable Page |
1. TRANS. ROLR CLEAN | Cleans the transcription roller. | Transcription Roller |
2. DRUM CLEANING | Cleans the drum. | Drum Unit |
3. FIX.UNIT CLEANING | Cleans the fuser roller. | Fuser Roller |
4. FEEDER CLEANING*1 | Cleans the ADF. | Cleaning the ADF Automatically |
5. SPECIAL MODE M | Sets to improve print quality or fix irregular print density. If print quality decreases or an irregularity in the print density appears, transcription output may not function adequately. | |
MID |
Selects in normal conditions. | |
LOW |
Selects to compensate for poor print quality that occurs when using paper that was stored for a long time at high temperatures and high humidity. | |
HIGH |
Selects to compensate for poor quality that occurs when using heavyweight paper. | |
6. SPECIAL MODE N | When the two-sided printing function is used, paper may curl severely or become jammed. Enable this setting to prevent paper curling or jamming.
|
|
7. SPECIAL MODE P | Sets to activate when lightweight paper or paper which is easy to get uneven print density is used for printing.
|
|
8. SPECIAL MODE S | Sets whether to reduce the waiting time for the next printout. When you change the paper size after continuous printing, the machine may take a while to start the next printing. |
|
OFF |
Does not reduce the waiting time next set of printout. (default) | |
SPEED PRIORITY |
Reduces the waiting time to start the next set of printout. Print speed has priority; however, it is possible that a previously printed image may be printed faintly on the next output. |
|
9. CONT. PRINT MODE | Sets whether to prevent the back edge of the previous page from appearing on the following page during continuous printing of half-tone prints or photographs.
|
|
10.BACK EDGE MODE | Sets whether to prevent back edge of paper from smudging.
|
|
11.LARGE PAPER MODE | Sets whether to improve toner fix on large size paper.
|
|
12.AUTO ADF DRTY ADJ*1 | Sets whether to activate smudge (due to dust or dirt) reduction during printing. When the ADF is dirty, copies may contain unwanted dots or lines.
|
Adjusting Feeder Smudge |
13.MAINTENANCE CODE | This setting is not functional in this model. |
*1 Not applicable for imageRUNNER1025. |