Setting IPv4 Address Automatically |
If you use a network environment which can automatically assign IP addresses, such as a network with a router (a DHCP server), you can set the machine to automatically obtain an IPv4 address. In this setting, the machine will automatically obtain an IP address after being connected to the network for a few moments. |
Remark |
|
||||||
|
|
If the screen appears prompting you to enter the System Manager ID and System Password, enter the System Manager ID and System Password using - (numeric keys), then press (Log In/Out). |
|
|
|
|
|
|
|
The settings entered in this step are used when the machine cannot obtain the necessary information for communication via DHCP, BOOTP or RARP. |
The settings entered in this step are used when the machine cannot obtain the necessary information for communication via DHCP, BOOTP or RARP. |
The settings entered in this step are used when the machine cannot obtain the necessary information for communication via DHCP, BOOTP or RARP. |
|
Turn OFF the machine and wait at least 10 seconds before turning it ON again. |